6) Clamp the neutral switch wire with the clip A and set the clip A on the neutral switch bracket. [2] NEUTRAL SWITCH 2P CONNECTOR [3] CONNECTOR BRACKET A 7) Connect the neutral switch 2P connector and set the neutral switch 2P connector on the connector bracket A. [1] FUEL TUBE HOLDER 8) Set the fuel tube holder on the connector bracket A. [7] NEUTRAL SWITCH BRACKET 9) Clamp the fuel tube A on the connector bracket A. 10) Set the harness band clip that clamps the alternator fuse cable on the neutral switch bracket.
[4] CLIP A [5] HARNESS BAND CLIP [6] ALTERNATOR FUSE CABLE 11) Install the neutral switch bracket by aligning a small hole in the neutral switch bracket with the boss on the seal holder while pulling the detent arm to your side. Tighten the 6 x 14 mm flange bolt securely. [1] (Pull in the direction of the arrow.) 6 x 14 [2] HOLE [5] DETENT ARM [4] BOSS [3] NEUTRAL SWITCH BRACKET 12) Apply marine grease to the concave in the shift arm and to the shift shaft B. Pulling the detent arm to your side, install the shift arm on the shift shaft B. [2] SHIFT ARM [1] DETENT ARM [3] SHIFT SHAFT B [5] Pull to your side. [4] (MARINE GREASE) 17-18