honda — Shift Arm/Neutral Switch

13) Set the 12 mm washer on the shift shaft B and secure with the 12 mm snap ring. [1] 12 mm SNAP RING [2] 12 mm WASHER [3] SHIFT ARM [Set in the “N” (Neutral) position.] 14) Apply marine grease to the outer surface of the link pin of the shift link bracket and to the long hole in the shift arm. Set the link pin aligning with the long hole in the shift arm. 15) Tighten the shift link bracket assembly with the two 6 x 18 mm flange bolts securely. 16) Apply marine grease to the mounting part of the linkage pivot on the throttle plate and to the linkage pivot. Install the linkage pivot on the throttle plate.

17) Apply marine grease to the outer surface of the shift link pin and install the remote control cable (shift side) (P. 17-7). 18) Apply marine grease to the outer surface of the link pin and install the remote control cable (throttle side) (P.17-10). 19) Remove the following parts. – Remote control cable/grommet (P. 17-5) – L./R. engine under covers (P. 4-14) – Front separate cover (P. 4-7) – Engine cover (P. 4-2) [2] THROTTLE PLATE [3] THROTTLE ROD [1] SHIFT ARM 6 x 18 (2) [4] (MARINE GREASE) [5] SHIFT LINK BRACKET ASSEMBLY [6] LINK PIN [4] (MARINE GREASE) [4] (MARINE GREASE) 17-19