5) Remove the gear shaft and the gear shaft stopper. Remove the internal gear and the overrunning clutch. [1] GEAR SHAFT STOPPER [2] ONE-WAY CLUTCH [4] INTERNAL GEAR [3] GEAR SHAFT • BRUSH HOLDER DISASSEMBLY 1) Remove the clip and the plate. [1] PLATE 2) Remove the brush sets and the brush springs. [4] BRUSH SPRING (4) [2] BRUSH SET [3] BRUSH HOLDER c. INSPECTION • BRUSH LENGTH Measure the brush length. Replace the brushes as a set if the measurement is less than the service limit. 18-5 STANDARD SERVICE LIMIT 12.3 mm (0.48 in) 7.0 mm (0.28 in)