honda — Electrical Equipment

• SHORT-CIRCUIT TEST — CORE-TO- COMMUTATOR Check for continuity between the commutator and armature coil core. If continuity exists, replace the armature. • SHORT-CIRCUIT TEST — SHAFT-TO-ARMATURE Check for continuity between the armature and armature shaft. If there is continuity, replace the armature. • OVERRUNNING CLUTCH 1) Check the overrunning clutch for smooth axial movement. If the overrunning clutch does not move smoothly, clean the spline and coat it with grease before recheck. If the overrunning clutch does not move smoothly after cleaning or coated with grease, replace the overrunning clutch assembly. 2) Turn the gear shaft assembly by holding the overrunning clutch.

The gear shaft assembly should turn only clockwise. If the clutch turns freely in both directions or if it does not turn at all, replace the overrunning clutch. 3) Check the pinion gear teeth for wear and damage and replace if necessary. NOTICE If the pinion gear is worn or damaged, the flywheel ring gear must be inspected. 18-8