• MAGNETIC SWITCH After assembly, check for continuity between the S terminal and the yoke (ground). Check for continuity between the S terminal and the M terminal. [1] S TERMINAL d. ASSEMBLY [2] M TERMINAL NOTICE After assembling the starter motor, apply sufficient amount of the water resisting sealant (Sumitomo 3M Padding Sealer #8533 or equivalent) to the mating sections of each part (P. 17- 19). [4] BRUSH SET Replace as a set. [5] PLATE [6] REAR BRACKET [1] BRUSH HOLDER [2] BRUSH SPRING (4) [7] 5 x 8 mm SCREW (2) 2.5 N . m (0.25 kgf . m, 1.8 lbf . ft) [27] YOKE [3] GASKET ASSEMBLY: Check the inner wall of the magnetic part for the foreign material (nut, washer, etc.) before assembly.
[8] ARMATURE [26] 6 x 22 mm SCREW (2) 6 N . m (0.6 kgf . m,, 4.3 lbf . ft) [25] SNAP RING [9] THROUGH BOLT (2) 5 N . m (0.5 kgf . m, 3.6 lbf . ft) [24] GEAR SHAFT STOPPER [23] O-RING (2) [10] OVERRUNNING CLUTCH [11] INTERNAL GEAR [12] GEAR SHAFT [13] STEEL BALL Do not reuse. [22] FRONT BRACKET [21] CLUTCH FORK [20] PLUNGER [19] PLATE [14] PLANETARY GEAR (3) [18] SPRING [16] GASKET [17] STARTER MAGNETIC SWITCH [15] 8 mm WASHER-NUT 18-9