honda — Electrical Equipment

• OVERRUNNING CLUTCH ASSEMBLY 1) Apply grease to the internal gear, inner wall of the overrunning clutch, gear shaft sliding surface and the surface of the gear shaft stopper. [1] GEAR SHAFT STOPPER [2] ONE-WAY CLUTCH 2) Assemble the overrunning clutch, gear shaft and the gear shaft stopper with the internal gear. 3) Install the new snap ring. 4) Holding the overrunning clutch, push the gear shaft into the overrunning clutch. Push the gear shaft stopper up to set the snap ring in the groove of the gear shaft stopper securely. [4] INTERNAL GEAR [3] GEAR SHAFT [5] SNAP RING [6] GEAR SHAFT STOPPER • BRUSH HOLDER ASSEMBLY 1) Install the brush springs and brushes on the brush holder.

Install the plate on the brush holder. [1] PLATE 2) Secure the plate with the clip. [4] BRUSH SPRING [2] BRUSH SET [3] BRUSH HOLDER [5] CLIP 18-10