• REAR BRACKET/YOKE ASSEMBLY 1) Install the brush holder on the armature. [1] 5 x 8 mm SCREW (2) 2) Apply grease to the armature shaft and install the gear bracket as shown. 2.5 N . m (0.25 kgf . m, 1.8 lbf . ft) 3) Apply the water resisting sealant (Sumitomo 3M Padding Sealer #8533 or equivalent) to the seat of each 5 x 8 mm screw. Tighten the 5 x 8 mm screws to the specified torque. [4] REAR BRACKET TORQUE: 2.5 N . m (0.25 kgf . m, 1.8 lbf . ft) [3] ARMATURE [2] BRUSH HOLDER 4) Check the inner wall of the yoke for foreign material and install the rear bracket/armature assembly. Install the rear bracket/armature assembly by aligning the grommet with the cutout in the yoke.
[1] ARMATURE/REAR BRACKET ASSEMBLY [2] YOKE 5) Install the plate and gasket on the front bracket. 6) Install the yoke/rear bracket assembly. Install by aligning the projection on the yoke with the cutout in the front bracket. [1] YOKE/REAR BRACKET ASSEMBLY [2] THROUGH BOLT (2) 7) Apply the water resisting sealant (Sumitomo 3M Padding Sealer #8533 or equivalent) to the seat of each through bolt. Tighten the through bolts to the specified torque. [3] GASKET TORQUE: 5 N . m (0.5 kgf . m, 3.6 lbf . ft) [5] FRONT BRACKET ASSEMBLY [4] PLATE 18-12