honda — Electrical Equipment

8) Apply the engine oil to the new O-rings and install the O- rings on the 6 x 22 mm screws. [1] 8 mm WASHER-NUT 9) Install the plunger, spring and the starter magnetic switch. Assemble the plunger and the clutch fork as shown. [2] STARTER MAGNETIC SWITCH 10) Tighten the 6 x 22 mm screws to the specified torque. TORQUE: 6 N . m (0.6 kgf . m, 4.3 lbf . ft) 11) Connect the brush terminal (M terminal) to the starter magnetic switch and tighten the 8 mm washer-nut securely. [3] SPRING [4] PLUNGER [4] PLUNGER [7] O-RING (2) Do not reuse.

[6] 6 x 22 mm SCREW (2) 12) After assembling the starter motor, apply sufficient amount of the water resisting sealant (Sumitomo 3M Padding Sealer #8533 or equivalent) to the following mating sections. 6 N . m (0.6 kgf . m, 4.3 lbf . ft) [5] CLUTCH FORK [3] [1] MAGNETIC SWITCH CASE CAULKING SECTION [2] WIRE, GROMMET AND REAR BRACKET [5] O-RING INSTALLATION PART [6] GASKET/FRONT BRACKET MATING SECTION [7] ENGAGEMENT SECTIONS WITH YOKE [8] SCREW/THROUGH BOLT AND REAR BRACKET MATING SECTIONS 18-13 WITCH ASSEMBLY/FR ACKET MATING SEC MOUNTING