24. SERVICE PROCEDURE STARTING 24.3.1 CHECK COOLANT LEVEL, ADD WATER \\ BEFORE AWWARNING Do not open the radiator cap unless necessary. When checking the coolant, always check the radiator reserve tank when the engine is cold. 1. radiator reserve tank @ (shown level is low, add in the diagram water through - on the right). FULL the water filler of reserve tank @ to the FULL level. 3. g iE Open the rear door on the left side of the machine and check that the cooling water level is between the FULL and LOW marks on lf the water 2. oe ) Ne 24.3 CHECK TT After adding water, tighten the cap securely.
Low AN113780 If the reserve becomes empty, first inspect for water leaks and then fill the radiator and the reserve tank with water. 24.3.2 CHECK OIL LEVEL the engine IN ENGINE OIL PAN, ADD OIL 1. Open hood. 2. Remove 3. Insert dipstick @ fully in the oil filler pipe, then take it out again. 4. The oil level should be between the H and L marks on dipstick ©. dipstick @ and wipe the oil off with a cloth. ASTSEBS ©. I If the oil level is below the L mark, add engine oil through oil filler NOTICE For details of the oil to use, see “20. USE AND 5. LUBRICANTS OF FUEL, COOLANT TO AMBIENT TEMPERATURE”. and check the oil level again. If the oi!
level is correct, tighten the oil filler cap close the engine hood. securely and REMARK When checking the oil level after the engine has been operated, for at least 15 minutes after stopping the engine before checking. If the machine is at an angle, make it horizontal before checking. 3-44 H 7 If the oil is above the H mark, drain the excess engine oil from drain valve ®, 6. ACCORDING AD052340