Komatsu PC210-6K — 24.3 CHECK BEFORE STARTING

24. SERVICE PROCEDURE 24.3.7 LUBRICATE @ CLAMSHELL BUCKET (12 POINTS) Prepare a grease pump. 1. Place the work equipment on the ground in a stable posture and stop the engine. 2. Using a grease gun, pump in grease through the grease fittings (12 points) shown by arrows. 3. After greasing, wipe off any old grease that was pushed out. AN113850 24.3.8 CHECK FOR SEPARATOR, WATER AND SEDIMENT DRAIN WATER IN WATER (OPTION) — The water separator separates water mixed in the fuel. If float @ is at or above red line (, drain the water according to the following procedure: 1. Loosen drain plug @ and drain the accumulated float reaches the bottom. Tighten drain plug @. 3.

If the air is sucked into fuel line when draining and water, be sure to bleed air in the same manner as for the fuel filter. See "24.6 3-48 SERVICE". Ort j water until the 2. EVERY 500 HOURS a Q~ —5 AE082240