24. 24.4 EVERY 24.4.1 100 HOURS SERVICE PROCEDURE SERVICE LUBRICATING NOTICE e e If any abnormal noise is generated from any greasing point, carry out greasing regardless of the greasing interval. Carry out greasing of greasing points 1 - 7 every 10 hours for the first 100 hours on a new machine. 1. Set the work equipment in the greasing posture below, then lower the work equipment to the ground and stop the engine. 2. Using a grease pump, pump fittings shown by arrows. 3. After greasing, wipe in grease through off any old grease that was the grease pushed out. 5 2,3,4 ZUR 6 7 8 9 10, 11 1 UF UU UT 12 AN114670 1. Boom cylinder foot pin (2 points) 2. Boom foot pin (2 points) 3.
Boom cylinder rod end 4. Arm cylinder foot pin (1 point) (2 points) 3-49