Angle Sensor-Accelerator [G643E and G643] Location Circuit Diagram ( G643 ) Description Angle Sensor-Accelerator is located in the accelerator pedal assembly. The engine speed management deals with a Drive-by-wire system. Drive-by-wire refers to the fact that the MI-07 control system has no throttle cable from the foot pedal to the throttle body. Instead, the ECM is electronically connected both to the foot pedal assembly and the throttle body. The SECM monitors the foot pedal position and controls the throttle plate by driving a DC motor connected to the throttle. The DC motor actuates the throttle plate to correspond to the foot pedal position when the operator depresses the pedal.
The SECM will override the pedal command above a maximum engine speed and below a minimum idle speed. The foot pedal assembly uses two potentiometers to detect pedal position. These two signals, accelerator pedal position 1 (APP1) and accelerator pedal position 2 (APP2) are sent directly to the SECM. The SECM uses a series of algorithms to self calibrate and cross check the signals from the pedal assembly. Circuit Diagram [G643E] [Harness Connectors] Inspection 1. Disconnect the Accelerator Pedal’s connector from the main engine harness. 2. Inspect the electrical conditions with a follow basic specification.
Signal output is on condition that input voltage is ....................................................... 5V±0.5% Rated current :....................................... 20 mA Power : ............................................... 100 mW Wire width :.......................................... 20AWG - At start point : Signal ’A’................... 0.4V±0.1V Signal ‘B’................... 4.5V±0.1V - At end point(Push for end) : Signal ’A’............... 3.60V±0.15V Signal ‘B’............... 1.39V±0.15V 3. If the result value is out of the specification, replace the Accelerator Pedal. G643(E) Service Manual Chapter 5. Engine Management System (EMS) 190