Doosan G643 LP Engine — Doosan G643 LP Engine User Manual

14. Use the accelerator pedal to increase RPM above idle momentarily (rev the engine) then release the pedal to return to idle RPM. The duty cycle setting should remain within the adjustment range (50-55%). Place your thumb over the adjustment port for a more accurate reading by preventing air from leaking past the mixture adjustment screw, which may cause the duty cycle to decrease. NOTE : If the FTV Duty Cycle reading is NOT between 25-60%, check for possible vacuum leaks, manifold leaks, or a faulty mixer. 15. Turn the ignition key to the OFF position to shut down the engine. 16.

Install the tamper proof cap on the idle mixture screw adjustment port using a large pin punch, so that no further adjustments can be made (Figure 36). Figure 42. Installing Tamper Proof Cap Field Adjustment Procedure: The idle mixture adjustment should only be necessary on a new mixer that does not have the tamper proof cap installed. The method for making the idle mixture adjustment to a running engine is to use the Service Tool software by connecting a laptop computer to the SECM. If you do not have the Service Tool a multimeter capable of measuring duty cycle, such as a Fluke 87 III, can be used.

If using a multimeter, connect the meter positive lead to between battery positive and the meter negative to the FTV signal wire. For the Fluke 87, press the “RANGE” button until 4 or 40 appears in the lower right-hand corner of the display. Press the “Hz” button twice so that the percent sign (%) appears on the right-hand side of the display. The multimeter will then read the duty cycle percentage the same as the Service Tool shown in Figure 41. 1. After installing a new mixer, operate the engine Bon LPG fuel. Start the engine and permit it to warm up until the coolant temperature (ECT on Mototune display) is approximately 167°F (75°C). 2. Place the transmission in Neutral. 3.

Mototune display parameter LP Fuel Control must display “Closed Loop”. 4. Use the Mototune Service Tool to monitor Duty Cycle % on the Mototune display. 5. To adjust the idle mixture screw, use a hex or Allen-type wrench. Turning the screw in (clockwise) should increase the duty cycle; turning the screw out (counterclockwise) should decrease the duty cycle. 6. Adjust the idle mixture screw on the mixer until a reading of 45-55% is reached for the FTV Duty Cycle in Closed Loop Idle (Figure 41). If engine idle performance is unstable screw the idle screw in slightly to see if stability is obtained, but in no case should duty cycle exceed 60%. 7.

Use the accelerator pedal to increase rpm above idle momentarily (rev the engine) then release the pedal to return to idle rpm. The duty cycle setting should remain within the adjustment range (45- 55%). Place your thumb over the adjustment port for a more accurate reading by preventing air from leaking past the mixture adjustment screw, which may cause the duty cycle to decrease. G643(E) Service Manual Chapter 6. LPG FUEL DELIVERY SYSTEM 203