OPERATION V-Shape Loading Stop the truck with the angle of about 60” toward the scooping direction of the wheel loader. After scooping the soil, back the wheel loader in such a way that it makes a right angle to the truck. The loading on the truck is made by the wheel loader going forward. The smaller the turning angle, the higher the efficiency. However, turning of 90” can be made if necessary. PARKING MACHINE A WARNING! Never leave the machine with the engine running or the bucket raised. When parking the machine, stop the engine, lower the bucket to the ground, place the transmission in neutral (N), apply the parking brake, turn off the electrical starting switch, and remove the key.
WARNING! Park the machine in a non-traffic area. If parking in traffic lanes cannot be avoided, provide appropriate flags, barriers, flares and warning signals. Also provide advance warning signals in the traffic lane for approaching traffic. A WARNING! Avoid parking on a slop because unexpected machine movement may occur. If necessary to park on a slope, park at a right angle to the slope and block the tires. A WARNING! Before starting the engine or when the machine is standing with the engine running: Place the transmission in neutral (N), apply the parking brake, and lower all raised work equipment. A Park machine in an area free of grease and fuel puddles which cause tire deterioration.
Lower hydraulically supported equipment to the ground to avoid unexpected movement and damage possibilities. Park on level ground to obtain accurate coolant, lubricant and fuel level checks. A WARNING! Always lock up the machine, including any anti-vandalism attachment, when leaving it unattended. 2-58