Komatsu — 250 HOUR LUBRICATION AND MAINTENANCE CHECKS

Lubrication & Service - Section 40 OM4036 Page 40-10 250 HOUR LUBRICATION AND MAINTENANCE (Continued) 3. 4. 5. 6. 7. FIGURE 40-5. FIGURE 40-6. TASK COMMENTS CHECKED INITIALS FUEL FILTERS - Change the fuel filters (fuel separa- tors). Refer to Cummins Operation & Maintenance manual for specific filter replacement instructions. FUEL TANK - Drain water and sediment from the fuel tank. Refer to Section B, Fuel Tank - Cleaning. STEERING LINKAGE - Check the torque on pin retaining nuts (1, Figure 40-6) on the steering linkage. (525 ft.lbs. (712 N.m) Check the torque on tie rod retaining nuts (2). (310 ft.lbs.

(420 N.m) HYDRAULIC PUMP DRIVESHAFT & U-JOINTS - Add one or two applications of grease to each grease fitting. Check that each bearing of the cross & bearing assembly is receiving grease. Lube Key “D”. REAR WHEEL MOUNTING - Using a mirror on a long rod and a flashlight, inspect all inner and outer wheel mounting nuts/studs for any evidence of looseness, damage, or missing hardware. If wheel mounting nuts/studs must be secured or replaced, the outer wheel must be removed for access. Refer to the Shop manual, Section G, for these procedures.