Komatsu — 250 HOUR LUBRICATION AND MAINTENANCE CHECKS

OM4036 Lubrication & Service - Section 40 Page 40-11 250 HOUR LUBRICATION AND MAINTENANCE (Continued) 8. 9. 10. 11. * 12. * This check is required only after the first 250 hours of operation (such as: the commissioning of a new truck, or after a new or rebuilt component installation), check: FIGURE 40-7. TASK COMMENTS CHECKED INITIALS REAR AXLE HOUSING - Check the rear axle housing for fluid leaks by removing the two drain plugs on the bottom of the axle housing. If fluid is present, the cause must be found and corrected before releasing the truck to operation. MAGNETIC PLUG - Remove the magnetic plugs from the front wheel hub covers and inspect for debris.

Clean the plugs and perform any necessary repairs. Refer to Figure 40-7. MOTORIZED WHEELS - Check for the correct oil level. Rotate a magnetic plug to the 6 o’clock position and remove the plug. The oil level should be even with the bottom of the plug opening. Inspect the mag- netic plugs for ferrous materials. Service the wheel motor as necessary. Refer to Figure 40-8. WHEEL MOTOR OIL SAMPLING - Refer to Section G5, Wheel Motor, for oil sampling information. HYDRAULIC SYSTEM FILTERS - Replace filter ele- ments only after the initial 250 hours of operation; then at each 500 hours of operation thereafter. Check oil level. Add oil as necessary. Lube Key “B”.