Komatsu — 500 HOUR LUBRICATION AND MAINTENANCE CHECKS

Lubrication & Service - Section 40 OM4036 Page 40-12 500 HOUR LUBRICATION AND MAINTENANCE CHECKS Maintenance requirements for every 10, 50, & 250 hour Lubrication and Maintenance Checks should also be car- ried out at this time. NOTE: “Lube Key” references are to the Lubrication Chart. 1. 2. 3. 4. 5. 6. 7. 8. 9. Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIALS FINAL DRIVE CASE BREATHERS - Remove the breather elements for the motorized wheels. Clean or replace the elements.

HYDRAULIC SYSTEM FILTERS - Replace the tank breathers and high pressure filter elements. Check the oil level. Add oil as necessary. Lube Key “B”. HYDRAIR® SUSPENSION - Check for proper piston extension (front and rear). THROTTLE AND BRAKE PEDAL - Lubricate the trea- dle roller and hinge pins with lubricating oil. Lift the boot from the mounting plate and apply a few drops of lubricating oil between the mounting plate and the plunger. BODY-UP & HOIST LIMIT SWITCHES - Check oper- ation of the switches. Clean and adjust as necessary. HOIST ACTUATOR LINKAGE - Check operation. Clean, lubricate, and adjust as necessary. PARKING BRAKE - Refer to Section J, Parking Brake Maintenance.

Perform the recommended inspections. RESERVE ENGINE OIL SYSTEM (OPTIONAL) a. Check electrical system connections for tight- ness, corrosion and physical damage. Check the battery, oil pressure switch, junction boxes, remote control fill box and the circuit breakers. b. Examine all electrical cables over their entire length for possible damage. c. Examine all hoses, including those on the reserve tank and the ones leading to and from the engine. Check for leaks, cracks or other damage. Check all fittings for tightness, leakage or damage. WHEEL MOTOR OIL (Initial 500 hours only) - Change or filter wheel motor gear oil only after initial 500 hours or operation.

Wheel motor gear oil must be filtered or changed every 2500 hours of operation thereafter.