Komatsu — Engine Shutdown Switch

OM3202 Operator Cab And Controls - Section 32 Page 32-7 Hoist Control Lever Hoist control (3, Figure 32-3) is a four position hand- operated lever located between the operator seat and the center console (see illustration below). Ash Tray Ash tray (4, Figure 32-3) is used for extinguishing and depositing smoking materials. Do Not use for flammable materials, such as paper wrappers, etc. Be certain that all fire ash is extinguished! Lighter Lighter (5, Figure 32-3) may be used for lighting cigars/cigarettes. Always use caution with smok- ing materials! This socket may also be used for a 12 VDC power supply. L.H.

Window Control Switch Control switch (6, Figure 32-3) is spring-loaded to the OFF position. Raising The Dump Body Pushing the front of the switch raises the left side cab window. 1. Pull the lever to the rear to actuate hoist circuit. (Releasing the lever anywhere during "hoist up" will place the body in HOLD at that position.) Pushing the rear of the switch lowers the window. 2. Raise engine rpm to increase hoist speed. 3. Reduce engine rpm as the last stage of the hoist cylinders begin to extend and then let the engine go to low idle as the last stage reaches half-extension. R.H. Window Control Switch Control switch (7, Figure 32-3) is spring-loaded to the OFF position. 4.

Release hoist lever as the last stage reaches full extension. Pushing the front of the switch raises the right side cab window. 5. After material being dumped clears the body, lower the body to frame. Pushing the rear of the switch lowers the window. Refer to Operating Instructions - Dumping, for more complete details concerning this control Engine Shutdown Switch Engine shutdown switch (8, Figure 32-3) is used for engine shutdown by depress- ing this button and holding it until engine stops. Lowering The Dump Body: Move hoist lever forward to DOWN position and release. Releasing the lever places hoist control valve in the FLOAT position allowing the body to return to frame.

Use this switch to shutdown engine if engine does not shutdown by turning off keyswitch, or to shut- down engine without turning off 24 VDC electric cir- cuits. There is also a ground level engine shutdown switch at the left front corner of the truck.