Komatsu — 20.2.4 INHIBITORS/CONDITIONERS

20.2.4 INHIBITORS/CONDITIONERS 1. All cooling system inhibitors, including those in antifreeze solutions, become depleted through normal operation. If the inhibitors in antifreeze are allowed to become depleted, the antifreeze becomes corrosive and attacks and coats the metallic surfaces of the cooling system which reduces heat transfer. Cooling system conditioners which contain these inhibitors must be added to maintain corrosion protection. 2. SOLUBLE OIL IS NOT RECOMMENDED for use in this engine as its use will reduce heat transfer. 3. There are no miracle additives that will increase heat transfer or prevent overheating. Conditioned water is still the best coolant.

Maintenance of Cooling System Inhibitors Keeping the engine coolant properly inhibited will keep the engine and radiator free of rust, scale deposits and corrosion. New vehicles are delivered with Antifreeze protection. Each time the coolant is drained and replaced, the coolant must be recharged with DCA4. New coolant can be correctly charged with supplemental coolant additives by using DCA4 concentrate listed in the table DCA4 Unit Guide. If coolant is added between drain intervals, additional DCA4 will be required. Coolant Testing for Conditioner Concentration DCA4 UNIT GUIDE Fleetguard Part No.

DCA4 Units DCA4 Liquid DCAGOLDCA80L 4 - 0.473 e (1 pt) 1760 - 208 0 (55 gal) DCA4 Powder DCA95 20 When the cooling system is maintained as recommended, the conditioner concentration should be satisfactory. The DCA4 concentration must not fall below 1 .O unit per 3.8 0 (1 gal) or exceed 2 units per 3.8 r? (1 gal). The only accurate method for testing chemical concentrations in coolant with mixed chemical compounds is a laboratory analysis. For this reason, the coolant inhibitor should be maintained, see 23 MAINTENANCE SCHEDULE CHART on page 3-23. REMARK Inadequate concentration of the coolant additive can result in major corrosive damage to cooling system components.

Over-concentration can cause formation of gel that can cause restriction, plugging of passages and overheating. Replenishing the Coolant Conditioner When antifreeze is added, add coolant conditioner equal to 1 .O unit per 3.8 Q (1 gal) of antifreeze. REMARK Mixing of DCA4 and other supplemental coolant additives is not recommended because there is currently no test kit available to measure concentration levels with mixed chemical solutions. 3-l 3