MAINTENANCE 24.6 EVERY 250 HOURS SERVICE 24.6.1 REPLACE ENGINE OIL FILTER The lubricating oil filter is a spin-on type. This filter cannot be cleaned and should not be disturbed except when it is necessary to replace it. REMARK Use only recommended filters available from your Komatsu distributor. After reaching operating temperature, stop the engine and drain the crankcase oil, see 24.6.2 CHANGE ENGINE CRANKCASE OIL on page 3-39. Clean the outside of the filter. Remove the spin-on type filter by turning it counterclockwise. Discard the old filter in a suitable, covered refuse container. Fill the new filter element with clean engine oil and apply a little clean engine oil to the seal.
Thread the filter on by hand (do not spin) by turning it clockwise until the seal just makes contact the filter header. Give the element an additional % to % turn. Change the crankcase oil, see 24.6.2 CHANGE ENGINE CRANKCASE OIL on page 3-39. REMARK Do not over tighten the filter or use any tools for installation because this can damage the gasket and filter. REMARK Mechanical over tightening may distort the filter header threads or damage the element seal. 3-38