Komatsu — 24.6.3 CHECKING FINAL DRIVE OIL LEVEL

24.6.2 CHANGE ENGINE CRANKCASE OIL a WARNING Hot parts - wear gloves. Fire hazard - do not smoke. Whenever working under the machine, turn off the electrical system master switch and tag the controls to prevent inadvertent starting. a WARNING 1. After reaching operating temperature, stop the engine. Remove the oil pan door to gain access to the crankcase oil pan drain plug. 2. Reach up through the access opening and remove the crank- case oil pan drain plug. Allow the oil to drain completely into a suitable container. Remove the spin-on engine oil filter, see 24.6.1 REPLACE ENGINE OIL FILTER on page 3-38. 3. Reinstall and tighten the crankcase drain plug. Reinstall the oil pan door.

Replace the spin-on oil filter, see 24.6.1 REPLACE ENGINE OIL FILTER on page 3-38. 4. Remove the engine oil filler cap (1). Fill the crankcase with the quantity and grade oil specified. Reinstall and secure the filler cap. Operate the engine at low idle until normal oil pressure registers on gauge. + For details of the fluid to use, see 20 USE OF FUEL, COOL- ANT AND LUBRICANT ACCORDING TO AMBIENT TEMPER- ATURE on page 3-8. 24.6.3 CHECKING FINAL DRIVE OIL LEVEL Position the machine on level ground. Remove the magnetic filler and level plug, check the lubricant and, if the lubricant is low, fill to the level of the plug opening. Also, check the plug for metallic particles that may be present.

If this condition continues after periodic checks, consult your Komatsu distributor. Reinstall the plug and tighten. When working under the machine, turn off the electrical system master switch and tag the controls to warn against starting the machine. -7 a WARNING + For details of the fluid to use, see 20 USE OF FUEL, COOL- ANT AND LUBRICANT ACCORDING TO AMBIENT TEMPER- ATURE on page 3-8. 3-39