MAINTENANCE 24.6.4 REPLACE FUEL FILTER WATER SEPARATOR When to Replace the Filter Replace the fuel filter when the engine is misfiring, loss of power is evident or after 250 hours. Replacing the Fuel Filter Keep the new filter in the original package until ready for installa- tion. Before loosening the filter, clean the filter head to prevent dirt or foreign material from entering the system. 1. Close the fuel shutoff valve under the fuel tank. 2. Remove the fuel filter from the filter header by turning counter- clockwise. A filter removal wrench can be used if unable to turn the filter by hand. Discard the fuel filter in a suitable container. 3.
Thoroughly clean the filter header with kerosene or diesel fuel to prevent dirt or foreign material from falling into the new filter. 4. Fill fuel filter with clean fuel. 5. Apply a light coating of clean engine oil or chassis grease to the seal surface on the new filter. 6. Install, but do not spin, the new filter, turning it until the seal just contacts the filter head. Make aligning marks on the filter and the filter header and tighten the filter an additional % to ‘/2 turn. Open the fuel line shutoff valve. REMARK Do not over tighten the filter or use any tools for installation because this can damage the gasket and filter.
REMARK Mechanical over tightening may distort the filter header threads or damage the element seal. 3-40