24.6.5 CHECK ENGINE DRIVE BELT FOR WEAR I * WARN’NG I Keep clear of fan and fan belts when the engme IS running. Rotating fan and belt contact can cause injury. Replace badly worn, greasy or cracked belts immediately. These conditions prevent proper belt function. Visually inspect the drive belt for intersecting cracks. Transverse (across the belt width) cracks are acceptable. Longitudinal (direction of belt length) cracks that intersect with transverse cracks are not acceptable. Replace the belt if it is frayed or has pieces of material missing. 24.6.6 CHECK OPERATION OF THE DECELERATOR INITIAL PEDAL HEIGHT 137 mm (5.4 in.) This pedal overrides the engine speed control lever setting.
Partial depression of the pedal decreases engine speed for smoother changes in machine direction and to ease the machine up to a load. Release the pedal to accelerate to the engine speed control lever setting. This pedal stops the machine when fully depressed. It also serves as a parking brake when the brake pedal lock is applied. Periodic adjustment of the pedal might be required, refer to your Komatsu distributor if pedal values are not within those shown. 24.6.7 REVERSE REVERSIBLE FAN BLADES Keep clear of fan and fan belts when the engine IS runnmg. Rotating fan and belt contact will result in serious injury.
The fan blades must be reversed to prevent corrosion and dirt build up that may cause binding of the shafts in the fan hub. After reversing the blades return the blades to the desired position. 3-41