Komatsu — 12.3.2 IN COLD AREAS (AUTOMATIC WARM UP OPERATION)

OPERATION 7. Check that there is no abnormal exhaust gas color, noise, or vibration. If any abnormality is found, repair it. 8. Press mode switch (2) until required operation mode light is turned on. 12.3.2 IN COLD AREAS (AUTOMATIC WARM UP OPERATION) When starting the engine in cold areas, carry out the automatic warm up operation after starting the engine. When the engine is started, if the engine coolant temperature is low (below 30 E C, 86 E F), the warm up operation is carried out automatically. The engine speed is automatically raised to 1400 RPM.

The automatic warm up operation is canceled automatically if the engine coolant temperature reaches the specified temperature (30 E C, 86 E F) or if the warm up operation is continued for 10 minutes. The automatic warm up operation is also canceled automatically if the fuel control dial is manually held at more than 70% of full speed for more than 3 seconds. When the automatic warm up operation is cancelled, the engine speed will return to the desired speed by setting the fuel control dial. If the engine coolant temperature or hydraulic oil temperature are low after the automatic warm up operation, warm the engine up further as follows.

NOTICE When the hydraulic oil is at a low temperature, do not carry out operations or move the levers suddenly. Always carry out the warm up operation. This will help to extend the machine life. Do not suddenly accelerate the engine before the warm up operation is completed. Do not run the engine at low idle or high 2-59