MAINTENANCE 18. OUTLINES OF SERVICE ! Use genuine Komatsu parts for replacement. ! When changing or adding oil, do not use a different type of oil. ! Unless otherwise specified, the oil and coolant used at the time of shipment from the factory are as shown in the table below. 18.1 OUTLINE OF OIL, FUEL, COOLANT 18.1.1 OIL ! Oil is used in the engine and work equipment under extremely severe conditions (high temperature, high pressure), and it deteriorates with use. Always use oil that matches the grade and temperature for use given in the Operation & Maintenance Manual. Even if the oil is not dirty, always replace the oil after the specified interval. !
Oil corresponds to blood in the human body, so always be careful when handling it to prevent any impurities (water, metal particles, dirt, etc.) from getting in. The majority of problems with machines are caused by the entry of such impurities. Take particular care not to let any impurities get in when storing or adding oil. ! Never mix oils of different grades or brands. ! Always add the specified amount of oil. Having too much oil or too little oil are both causes of problems. ! If the oil in the work equipment is not clear, there is probably water or air getting into the circuit. In such cases, please contact your distributor. !
When changing the oil, always replace the related filters at the same time. ! We recommend you have an analysis made of the oil periodically to check the condition of the machine. For those who wish to use this service, please contact your distributor. 18.1.2 FUEL ! The fuel injection pump is a precision instrument, and if fuel containing water or dirt is used, it cannot work properly. ! Be extremely careful not to let impurities get in when storing or adding fuel. ! Always use the fuel specified in the Operation & Maintenance Manual.
Fuel may congeal depending on the temperature when it is used (particularly in low temperature below -15 E C(5 E F), so it is necessary to change to a fuel that matches the temperature. ! To prevent the moisture in the air from condensing and forming water inside the fuel tank, always fill the fuel tank after completing the day’s work. Before starting the engine, or when 10 minutes have passed after adding fuel, drain the sediment and water from the fuel tank. ! If the engine runs out of fuel, or if the filters have been replaced, it is necessary to bleed the air from the circuit.
3-4 Item Kind of fluid Engine oil pan SAE 15W-40 API classification CF-4 Swing machinery case, final drive case, Damper case SAE 30 API classification CE Hydraulic tank SAE 10W API classification CD Fuel tank ASTM D975 No. 2 (However, ASTM D975 No. 1 is used for the winter season (October to March) Radiator Ethylene glycol antifreeze 50/50 mix with water