MAINTENANCE 18.1.3 COOLANT ! Use water that has a low mineral content. Water used with antifreeze should meet the following guidelines. Total Hardness - Not to exceed 300 parts per million to prevent scale deposits. Water containing dissolved magnesium and calcium (the usual reason for water hardness) above the specified amount will cause scale deposits to develop in the engine. Chlorides - Not to exceed 100 parts per million to prevent corrosion. Sulfites - Not to exceed 100 parts per million to prevent corrosion. ! When using antifreeze, always observe the precautions given in the Operation & Maintenance Manual. !
These machines are supplied with Komatsu original antifreeze in the coolant when the machine is shipped. This antifreeze is effective in preventing corrosion of the cooling system. The antifreeze can be used continuously for two years or 4000 hours. Therefore, it can be used as it is even in hot areas. ! Antifreeze is inflammable, so be extremely careful not to expose it to flame or fire. ! The proportion of antifreeze to water differs according to the ambient temperature. For details of the mixing proportions; See ? COOLING SYSTEM on page ?-?. ! If the engine overheats, wait for the engine to cool before adding coolant. !
If the coolant level is low, it will cause overheating and will also cause problems with corrosion from the air in the coolant. 18.1.4 GREASE ! Grease is used to reduce friction and help prevent twisting and noise at joints. ! The nipples not included in the maintenance section are nipples for overhaul, so they do not need grease. If any joint becomes stiff after being used for a long time, add grease. ! Always wipe off all of the old grease pushed out when greasing. Be particularly careful to wipe off the old grease in places where sand or dirt sticking to the grease would cause wear of the rotating parts. 18.1.5 STORING OIL AND FUEL !
Keep indoors to prevent any water, dirt, or other impurities from getting in. ! When keeping drum cans for a long period, put the drum on its side so that the filler port of the drum can is at the side (to prevent moisture from being sucked in). If drum cans have to be stored outside, cover them with a waterproof sheet or take other measures to protect them. ! To prevent any change in quality during long term storage, be sure to use in the order of first in first out (use the oldest oil or fuel first). 18.1.6 FILTERS ! Filters are extremely important safety parts. They prevent impurities in the fuel and air circuits from entering important equipment and causing problems.
Replace all filters periodically. For details, see the Operation & Maintenance Manual. However, when working in severe conditions, it is necessary to consider replacing the filters at shorter intervals according to the oil and fuel (sulfur content) being used. ! Never try to clean the filters (cartridge type) and use them again. Always replace with new filters. ! When replacing oil filters, check if any metal particles are stuck to the old filter. If any metal particles are found, please contact your distributor. ! Do not open packs of spare filters until just before they are to be used. ! Always use genuine Komatsu filters. 3-5