MAINTENANCE 18.2 OUTLINE OF ELECTRICAL SYSTEM ! If the wiring gets wet or the insulation is damaged, the electrical system leaks and this could result in a hazardous malfunction of the machine. ! Services relating to the electrical system are (1) check of fan belt tension, (2) check of damage or wear in the fan belt and (3) check of battery fluid level. ! Never remove or disassemble any electrical components installed in the machine. Never install any electrical components other than these specified by Komatsu. ! Be careful to keep the electrical system free of water when washing the machine or when it rains. !
Since the controller for the control system may cause a malfunction due to external wave interference; before installing a radio receiver and a walkie-talkie or citizen band, consult your distributor. ! When working near the seashore, carefully clean the electrical system to prevent corrosion. ! When installing a cooler or any other electrical equipment, connect it to an independent power source connector. The optional power source must never be connected to the fuse, starting switch, or battery relay. 18.3 OUTLINE OF HYDRAULIC SYSTEM ! During operation and immediately after operation is ended, the temperature of the hydraulic system still remains high.
In addition, high hydraulic pressure is applied to the system. Take care when inspecting and maintaining the hydraulic system. " Stop the machine on level ground, lower the bucket to the ground, then set so that there is no pressure applied to the cylinder circuit. " Always stop the engine. " Immediately after operations, the hydraulic oil and lubricating oil are at high temperature and high pressure, so wait for the oil temperature to go down before starting maintenance. Even when the temperature goes down, the circuit may still be under internal pressure, so when loosening the plug or screw, or the hose joint, do not stand in front of the part.
Loosen it slowly to release the internal pressure before removing it. " When carrying out inspection or maintenance of the hydraulic circuit, always bleed the air from the hydraulic tank to remove the internal pressure. ! Periodic maintenance includes the inspection of the hydraulic oil level, replacement of the filter and refilling of hydraulic oil. ! When a high pressure hose, etc. is removed, check the o-ring for damage. If necessary, replace it. ! After the hydraulic filter element and strainer are cleaned or replaced, or after the hydraulic system is repaired or replaced or the hydraulic piping is removed, bleed air from the hydraulic circuit. !
The accumulator is charged with high-pressure nitrogen gas. Incorrect handling may be dangerous. For the handling procedure, See 11.22 HANDLING ACCUMULATOR on page 2-42. 3-6