MAINTENANCE 18.4 OUTLINE OF FUEL SYSTEM ! Cleanliness of diesel fuel determines the service life of the fuel injection components. Water and contaminants, allowed to reach precision injection components, cause rapid wear and poor performance. Clean fuel and regular servicing of the fuel tank and fuel filtering components are necessary for long service life. Always clean the area around the fuel tank filler cap before refueling. WARNING ! Do not smoke while filling the fuel tank or servicing the fuel system because a fire or explosion could result. ! When filling the fuel tank, place the fuel nozzle against the side of the filler neck to reduce the chance of static electricity sparks. !
Never remove the fuel filler cap or fill the fuel tank while the engine is running or when the machine is indoors. The fumes are hazardous and a spark or flame could cause a fire or explosion. ! Before working on the electrical system, disconnect the negative (ground) battery cable. Tag the cable and controls to warn against starting. ! Never mix gasoline, gasohol, or alcohol with diesel fuel. This creates a fire or explosion hazard that could result in personal injury or death. 18.4.1 FUEL INJECTION PUMP Do Not Attempt to Adjust the Fuel Injection Pump Unsatisfactory operation of the engine may not be due to the fuel injection pump.
If unsatisfactory operation persists after servicing the filters, consult your distributor to service the fuel injection pump. Special equipment and knowledge are required for proper injection pump service. These are available at your distributor. 18.4.2 FUEL TANK ! Check the fuel level at the gauge on the control panel. The fuel level can also be checked using the sight gauge on the side of the fuel tank. To prevent moisture due to condensation, the fuel tank must be filled at the end of each day’s operation. Fuel is added by removing fuel cap (1) and adding fuel. If fuel cap breather holes (2) are clogged, fuel flow to the engine may stop.
Periodically check and clean the fuel cap breather holes. Draining Fuel Tank ! Loosen the valve on the bottom of the fuel tank. Drain the water and sediment from the tank until clean fuel appears. Close the valve. 3-7