MAINTENANCE 20.2 ENGINE OIL SPECIFICATIONS 20.2.1 NORMAL OPERATION Oil performance recommendations are as follows: ! The use of a quality engine lubricating oil combined with appropriate oil and filter change intervals are critical factors in maintaining engine performance and durability. ! Komatsu Engine Oil or multi-viscosity engine oil meeting American Petroleum Institute (API) performance classification CF-4, CG-4, CF-4/SG or CG-4/SH or MIL-L-2104D or E is recommended. NOTICE: Classification CD, CE, CD/SF or CE/SF oils may be used in areas where CF-4, CG-4, CF-4/SG or CG-4/SH oil is not yet available.
If API classification CC or CC/CD is used, reduce the engine oil change interval by half. ! A sulfated ash limit of 1.0 mass percent is suggested for optimum valve and piston deposit and oil consumption control. The sulfated ash must not exceed 1.85 mass percent. The sulfated ash limit of 1.85 mass percent has been placed on all engine lubricating oils recommended for use in the engine. Higher ash oils can cause valve and/or piston damage and lead to excessive oil consumption. ! The API service symbol displays the following information. The upper half of the symbol displays the appropriate oil categories; the lower half may contain words to describe oil energy conserving features.
The center section identifies the SAE oil viscosity grade. Oil viscosity recommendations are as follows: ! The use of a multi-grade lubricating oil has been found to improve oil consumption control and improve engine cranking in cold temperatures while maintaining lubrication at high operating temperatures. ! While SAE 15W-40 multi-viscosity oil is recommended for most operating climates, refer to the previous table for oil viscosity recommendations for extreme climates. NOTICE: Limited use of low viscosity oils, such as SAE 10W-30 may be used for easier starting and providing sufficient oil flow at ambient temperatures below -5 E C (+23 E F).
However, continuous use of low viscosity oils can decrease engine life due to wear. Single-graded oils may be used if multi-graded oil in not available, but be sure to use oil that matches the temperature in the table. ! Special "break-in" lubricating oils are not recommended for a new or rebuilt engine. Use the same type of oil during the "break-in" as specified for normal operation. ! Additional information regarding lubricating oil availability throughout the world is available in the "E.M.A. Lubricating Oils Data Book for Automotive and Industrial Engines.” The data book may be ordered from the Engine Manufacturers Association, 401 North Michigan Ave., Chicago, Il U.S.A. 60611.
The telephone number is (312) 644- 6610. 3-10