Komatsu — 24.2.2 CLEAN INSIDE OF COOLING SYSTEM

MAINTENANCE Filling System 12. Add coolant (antifreeze mixture) until it overflows from the coolant filler. When the coolant comes up to near the water filler port, close the after-cooler air drain valves (6). 13. To remove the air in the coolant, run for five minutes at low idle, then for another five minutes at high idle. When doing this, leave radiator cap off. 14. After draining the coolant from the reserve tank (5), clean the inside of the reserve tank and refill between FULL and LOW level. 15. Stop the engine, wait for about three minutes, add coolant up to near the radiator filler port, then tighten cap.

Cleaning Radiator Minor internal sludge accumulations will be removed when flushing the cooling system. When internal accumulations are found that cannot be removed by normal flushing methods, consult your distributor. Remove all bugs and dirt from the radiator core, using air or water under pressure. Direct the flow through the core, opposite to the normal direction of air flow. 3-30