z Install the bearing in the View from crankshaft pulley connecting rod cap and apply oil. Piston oil gallery Spray nozzle z Make sure that the manufacture CAUTION: Direction of snap ring is assembling to be positioned the opposite side serial numbers impressed on the connecting rod cap and connecting rod big end are identical, and install the connecting rod cap by aligning it with dowel pin. z Wet the fixing bolts with engine oil, semi-tighten them with hand, Serial no. tighten them to the specified torque using a torque wrench as follows. (1) First stage : Coat engine oil over bolts. (2) Second stage : Temporary bolt screwing about 1~2 threads (3) Third stage :
With torque wrench, tighten up to about 4 ~ 6 kg.m (4) Fifth stage : With torque wrench, tighten finally up to 9.75+0.5 kg.m . z When the connecting rod bearing cap bolts are tightened, check the connecting rod end play to the right and left with hand. If no end play is found, remove and reinstall or replace the connecting rod bearing. DL06 Diesel Engine Disassembly and Reassembly of Major Components 104 Torque 9.75+0.25 kg.m