Doosan DL06 — Doosan DL06 User Manual

3.3.18. Cylinder head z Blow the bolt holes of cylinder block with a compressed air and remove the foreign matter. z Clean the head gasket contact surface thoroughly. However, be careful for the foreign material not Part no. mark and Production date to enter into the combustion chamber. z Assemble the new head gasket by aligning the holes with dowel pins of cylinder block with the right‘s mark facing upward. z Check the inside of combustion chamber for foreign substances, Head bolt Torque wench and carefully mount the cylinder head in the block by aligning the dowel pin with the dowel pin hole. z Be careful not to damage the cylinder head gasket.

If the dowel pin is not in alignment, lift the cylinder head again and then remount it . z After tightening the cylinder head bolts, even at disassembling, the cylinder head gasket should be changed a new one. z Coat the cylinder head bolts with 13 17 21 25 26 engine oil, and tighten in proper 8 4 5 9 sequence to the specified torque 1 22 18 14 10 according to bolt tightening order. 12 16 20 24 2 3 7 6 23 19 15 11 DL06 Diesel Engine Disassembly and Reassembly of Major Components 108