3) Oil clearance between crankshaft and bearing (Method 2 : plastic gauge) z Assemble the crankshaft on the cylinder block and put plastic gauge on the journal and pin of crankshaft and then after assembling bearing cap, tighten the bolts at the specific torque. z Again after disassembling the bearing cap by removing the bolts, take out the flatted plastic gauge and measure the width of plastic gauge by means of plastic gauge measuring scale. This is the oil clearance. 4) Bearing spread and crush z Inspection Check to see that the bearing requires a considerable amount of finger pressure at reassembly operation.
Spread = φ A - φ B DL06 Diesel Engine Disassembly and Reassembly of Major Components 86