Doosan DL06 — Doosan DL06 User Manual

(5) Connecting rod inspection 1) Distortion z Check the connecting rod for distortion. As shown in the figure below, install the connecting rod to the connecting rod tester, and check for distortion using a feeler gauge. z If the connecting rod is found distorted, never re-use it but replace with a new one. 2) Holes alignment (parallelism) z Measure the alignment of the connecting rod piston pin bushing holes with connecting rod big end holes. 3) Wear z Assemble the connecting rod to the crankshaft and measure connecting rod big end side clearance using a feeler gauge.

z Assemble the connecting rod to the piston and measure connecting rod small end side z If the measured values are clearance. beyond the limit, replace the connecting rod. DL06 Diesel Engine Disassembly and Reassembly of Major Components 92 Standard Limit 0.02 mm 0.1 mm or less