INSTRUMENTS AND CONTROLS 51 7. Grade Gripper (Amber) (SCR) Grade Gripper provides anti-roll back assistance during the transition from a stopped position to starting on a grade. 7. Integrated Temp-A-Start (Amber) (If Equipped) (DPF) "Integrated Temp-A-Start" saves fuel by reducing the amount of time spent idling to keep the vehicle’s batteries charged, the engine warm, or the cab and sleeper comfortable. Once the optional ’Integrated Temp-A-Start’ feature is activated via a dash switch, the system will automatically start and stop the truck engine. Safety overrides prevent the system from activation if the transmission is in gear, the hood is up, or the parking brake is released.
Integrated Temp-A-Start voltage and temperature target settings are fully programmable through either VCADS service support software, or, if enabled via the Co-Pilot instrument cluster display 8. Pre-Heat Start Indicator (Amber) (If Equipped) Indicates that the intake pre-heat is enabled. Wait to start engine until light goes out. 9. Check Transmission (Amber) A amber tell-tale light that illuminates when transmission oil temperature reaches a pre-determined level (depending on transmission make and model) indicating an overheat condition or It may also come on if an active fault code is present in the transmission. 10.
Electronic Malfunction Indicator (Amber) Illuminates when V-MAC® detects an electronic malfunction. Refer to the V-MAC® IV Vehicle Management and Control with Co-Pilot® Display Operator’s Guide . The electronic malfunction lamp may turn on when operating the vehicle in a bob-tail mode with the engine brake turned on and cruise control active. Cruise control will become inoperative but can be reset by shutting off, then restarting the engine. This condition can be corrected by resetting the "Service Brake Fault Threshold with Engine Brake" function. Refer to V-MAC® IV Customer Data Programming. Note:
Consult the appropriate vendor engine manual if your vehicle is not equipped with a MACK engine. 11. Check Lamps 12. High Beam Indicator (Blue) – Indicates that high beams are on. 14. Left Turn Signal Indicator (Green) – Flashes green when the left turn signal is activated. 13. Parking Brake Indicator (Red) – Indicates that the parking brake is engaged.