WHEN REQUIRED b. CHECK, CLEAN AND REPLACE AIR CLEANER ELEMENT 9. When the water is completely clean, stop the engine and close drain valves (3). (4) and (5). Replace the corrosion resistor cartridge with a new part, and open the corrosion resistor valve (I 1. For details of replacement of the corrosion resistor, see EVERY 1000 HOURS SERVICE. Add soft water until it overflows from the water filler. To remove the air in the cooling water, run for 5 minutes at low idling, then for another 5 mi- nutes at high idling. When doing this, leave radiator cap (2) off. Stop the engine, wait for about 3 minutes, add soft water to the specified level, then tighten Use city water for the cooling water.
If river water, well water or 10 other such water supply must be used, contact your Komatsu distributor. Do not use any alcohol base antifreeze. Checking * Be sure to replace the corrosion resistor cartridge. A Do not remove the cap while cooling water is hot. Hot water may spout out. When removing radiator cap, lift the lever to relieve inner pressure. 11. 12. Whenever the red piston in dust indicator (I) appears, clean the air cleaner outer element. Stop the engine when cleaning the element. 13. cap (2). w-o.4317 - 107-