WHEN REQUIRED Replacing inner element 1. First remove the outer element. 2. Remove the inner element. Cleaning outer element The following methods require With compressed air spare parts. With water Dash city water (less than 3 kg/cm? on element from inside 3. Place the cover over the air intake part to prevent dust entering. 4. Clean the air cleaner body interi- or, then remove the cover from the air intake port. 5. Fit a new inner element and tight- en it with nuts. along folds, then from outside and again from inside. Dry and check it. With cleaning agent For removing oils and fats as well as carbon etc.
attached on the ele- ment, the element may be cleaned in lukewarm solution of mild deter- gent, then rinsed in clean water and left to drip dry. Drying can be speeded up by blowing dried compressed air less than 7 kg/cm21 from the inside to the outside of the element. Never attempt to heat the element. Using warm water (about 40°C) instead of soapy water may also be effective. Install the outer element and the cover. Push the dust indicator reset button. Direct dry compressed air (less than 7 kg/cm? to element from inside along its folds, then direct it from outside along its folds and again from inside, and check element.
A When using compressed air, wear safety glasses and other things required to maintain safety. Do not attempt to reinstall a cleaned inner element. A Do not clean or replace the air cleaner element with the engine running. w-04319 - 109-