Komatsu — HANDLING OF BATTERY

HANDLING OF BATTERY REMOVAL AND INSTALLATION OF BATTERY A ~. When removing battery, first disconnect the cable with the black tube from the ground (normally, from the negative (-) terminal). If a tool touches a cable connecting the positive terminal and the chassis, there is danger of sparks being emitted. When installing battery, the ground cable should be connect- ed to the ground terminal as the last step. There is a total of four batteries (two on each side) at the rear of the machine, and a total of two batteries at the ground end (one on each side of the machine). When removing or installing the batteries, always follow the above procedure for the batteries on both sides.

STARTING ENGINE WITH A BOOSTER CABLE When starting up the engine with a booster cable, do as follows: 1. Before connecting the booster cable 2. Connect the booster cables in the following manner. I) Connect one clip of booster cable A to the positive (+I terminal of the engine to be started. 2) Connect the other clip to the positive (+I terminal to the engine which is running. 3) Connect one clip of booster cable B to the negative (-1 terminal of the engine which is running. 1) Size of booster cable and clip should be suitable for the bat- tery size. 2) Check cables and clips for breaks, corroded surfaces, etc. 3) Make sure cables and clips are firmly secured.

Keep the starting switch in “OFF” position. 4) 4) Connect the other clip to the engine block to be started. Make sure the clips are firmly connected to battery terminals. Then, start the engine. 5) The battery of the running engine must be the same capacity as that of engine to be started. * Batterv for running to be started c (4 Engine block to be started &== f for engine w-04331 - 27 -