ce t — FAULT CODE LISTING

CX210/CX240 ELECTRONIC FUEL SYSTEM 8 - 22 CX EXCAVATORS FAULT CODE LISTING Fault Associated Hardware Reason Effect (only with active code) F367 VP44 fuel system IAT error Fuel pump position sensor signal lost. Fueling to injectors is stopped and engine shuts down. F368 VP44 Fuel system timing error. Fuel pump controller can not achieve valve sent from the ECM. Significant engine power loss. F369 VP44 Fuel system sync error. Fuel pump controller does not detect engine position pulse at pin 7 of the engine harness. Significant engine power loss. Possible white smoke. F372 VP44 Fuel system idle validation error.

Fuel pump controller detects continuous voltage, an open or a short at idle select pin 16 of the engine harness. If communication is lost between the ECM and FPCM, engine will only run at or near low idle. F373 VP44 Fuel system FSO is high. High voltage at VP44 shut off signal, pin 6 of the engine harness. Fueling to injectors is stopped and engine shuts down. F374 VP44 Fuel pump shut off error. Pump controller has detected an internal error. Response will vary from some power loss to engine shut down. F376 VP44 Fuel system mismatch error. No calibration in fuel pump controller. Fueling to injectors is stopped and engine shuts down. F377 Fuel pump power shut off relay.

Pump controller does not power down when key switch power is removed from the ECM. Insufficient battery voltage. F381 Intake air heater control error. (Rly2) Error detected in cold start relay 1 at pin 41 of the OEM harness. Insufficient heat, possible white smoke and hard starting.