CX210/CX240 ELECTRONIC FUEL SYSTEM 8 - 23 CX EXCAVATORS FAULT CODE LISTING Fault Associated Hardware Reason Effect (only with active code) F386 Engine sensor voltage high. High voltage at engine position sensor 5VDC at pin 10 of the engine harness. Default value used. Engine will de-rate to no boost fueling with loss of engine protection. F391 Fuel pump power shut off relay. Error detected at VP44 power relay enable circuit at pin 43 of engine harness. Possible no effect on engine or engine may not run. F415 Oil pressure sensor/ EPF Signal indicates pressure is below the very low engine protection limit. Speed de-rate and possible engine shut down. F418 Water in Fuel sensor.
Signal indicates the water in the fuel filter should be drained. Water in fuel can lead to severe fuel system damage. F422 Coolant level sensor Voltage at both high and low level signal pins 27 and 37 of the engine harness or no voltage at both . No engine protection for coolant level. F429 Water in Fuel sensor. Low voltage at WIF signal pin 40 of the OEM harness. No water in fuel protection. F431 Accelerator pedal position sensor low. Idle validation signals on pins 25 and 26 of the OEM harness indicates voltage detected simultaneously on both pins (open circuit) No effect on engine performance but loss of idle verification. F433 Boost pressure sensor high.
Signal indicates pressure is high when engine conditions indicate signal should be low. Possible over fueling during acceleration with increased black smoke. F434 Electronic Control Module Supply voltage to the ECM fell below 6 VDC for a fraction of a second or ECM was not allowed to power down correctly. Possible no performance effect or engine stopping or hard starting.