DRESSTA Co. Ltd. TD-40C98/1E — 5.8. COOLING SYSTEM

SECTION 5 MAINTENANCE Page 26 5.8. COOLING SYSTEM 5.8.6. CHANGING THE COOLANT Open L.H. side engine access door. Cooling system fast fill receiver is mounted to L.H. side of mainframe. To drain cooling system remove protective cover from the receiver and install drain pump adapter. Drain the system. Fill the cooling system using the same fast fill receiver “1” Fig. 5.10. Fast Filling Engine Systems 1. Cooling System Fast Fill And Drain Receiver 2. Engine Crankcase Oil Fast Fill And Drain Receiver 5.8.7. CHANGING COOLANT Every 250 hours of operation change coolant filter and check coolant for DCA concentration. Procedure is shown in Engine Operation Manual.

After 6000 hours of operation or every 2 years clean the cooling system as described in Engine Operation Manual. 5.8.8. CHANGING COOLANT (for machines without fast fill systems) 5.8.8.1. Draining the System 1. Run the engine until it reaches operating temperature, then stop the engine 2. Remove the radiator cap. Refer to ”RADIATOR CAP” 3. Open the oil cooler drain valve located on the bottom of the oil cooler 4. Open two crankcase drain valves, located at each side of the rear part of the crankcase 5. Open radiator drain valve located on lower tank on R.H. side of the machine. Access to the valve is gained after removal of front bottom guard. 6. Open coolant filter shut-off valve 7.

Allow the system to drain completely; do not let drain outlets plug up from foreign material. TD-40C DRESSTA