DRESSTA Co. Ltd. TD-40C98/1E — 5.10. ELECTRICAL SYSTEM

MAINTENANCE SECTION 5 Page 29 5.10. ELECTRICAL SYSTEM The surface under all terminals must be clean, and good electrical connections must be established after any reassembly. Also, all clips must grip cables tightly to prevent vibrations and rapid cable wear. All clips and straps must be closed in a workmanlike manner, so as not to damage the insulation. Batteries can only be charged using receptacle locate close to the engine on the left hand side of the machine. Receptacle can also be used to connect additional source of supply, e.g. for engine starting.

Batteries can be only be charged using this receptacle, which also can be used to for connection of additional source of power to start the engine under extreme conditions. 5.10.1. AUTOMATIC RESET CIRCUIT BREAKER Electrical circuits are protected by automatic reset circuit breakers mounted on the underside of the instrument panel. In the event of a short circuit or ground, the circuit breaker will open and close until trouble clears or is corrected. The circuit breaker will then return and stay in its normal closed position. 5.10.2. BATTERIES General Fig. 5.15. Location of Batteries The machine is equipped with two 12-volt battery. They are located in L.H. fender.

Access is provided upon removal of three bolts and lifting the cover. Never allow a battery to stand on concrete, ground or a metal support unless proper insulation is provided. A wooden platform or board is sufficient insulation. Be sure the battery is fastened securely to avoid damage from vibration. WARNING! A battery gives off highly flammable gas. Never allow sparks, open flame or lighted smoking material near the battery. Avoid spilling any electrolyte on hands or clothing. Always wear safety glasses when working on a battery. DRESSTA TD-40C