DRESSTA Co. Ltd. TD-40C98/1E — 5.13. HYDRAULIC SYSTEM

SECTION 5 MAINTENANCE Page 42 5.13. HYDRAULIC SYSTEM 5.13.5. SERVICING THE RESERVOIR BREATHER Fig. 5.31. Hydraulic Reservoir Breather Location 1. Park the machine on level ground, lower the blade to the ground and stop the engine. Turn the electrical master switch to OFF and remove the key. With the engine stopped, operate the equipment lever several times to relieve any pressure. Remove all outside dirt from breather. 2. Slowly loosen the filler plug on the reservoir in order to relieve any pressure in the reservoir. WARNING! Pressurized Reservoir. Always loosen the filler plug slowly in case there is still some pressure in the system. 3. Remove the breather (Fig. 5.31) from the reservoir.

Remove the lock ring (1), cover (2), element (3) and clean in a nonflammable commercial solvent. Dry thoroughly. Check O-ring (4) for wear or deterioration. Replace if necessary. Reinstall filter (3) and cover (2). Secure with lock ring (1). Reinstall the filler cap. Fig. 5.32. Hydraulic Reservoir Breather 1. Lock Ring 2. Element Cover 3. Breather Element 4. O-Ring TD-40C DRESSTA