MAINTENANCE SECTION 5 Page 45 5.15. MOUNTED EQUIPMENT 2. For machines with hydraulic tilt: Remove the bolts and remove cover (1). Remove hose clamp securing the hoses to the trunnion. Fig. 5.36. Blade Tilt Hoses Connection Location 1. Cover 3. Remove the pins securing the lift cylinder piston rods to the blade lift brackets at the back of the blade. Retract the piston rods fully into the cylinders. Secure the rods to the tractor using shipping hanger bars to prevent damage to the piston rods. 4. Remove 4 trunnion bearing cap bolts and remove caps and shims of R.H. and L.H. side trunnion from push arms. 5. Back the tractor straight out and away from the push arms. 6.
Reassemble shims and bearing caps to the push arms and secure with bearing cap bolts to prevent their damage or being lost. If the blade is to be stored outdoors, grease to prevent corrosion. To reassemble the blade perform the above in reverse order. Fig. 5.37. Push Arm Mounting 1. Trunnion Bearing Cap 2. Cap Bolts 3. Trunnion Ball 4. Push Arm 5. Trunnion Mounting Bolts 6. Shims 7. Tilt Cylinder Hose (rod end) 8. Tilt Cylinder Hose (piston end) DRESSTA TD-40C