SECTION 5 MAINTENANCE Page 48 5.15. MOUNTED EQUIPMENT Fig. 5.40. Diagonal Shimming 1. Diagonal Strut 2. Shims 3. Stress Reliever Lever 4. Cap Screws 5. Strut Cap 5.15.1.3. Upper Strut and Tilt Cylinder Adjustment The upper strut and tilt cylinder sockets must be checked occasionally to ensure excessive movement does not occur between the cap and blade socket. When movement exceeding 1.3 mm is detected readjustment is necessary. Adjust as follows: Attach a suitable hoist and sling to the upper stud or tilt cylinder (1). Remove cap screws (2) securing cap (5) to blade socket (4). Retract upper strut or tilt cylinder (1) while supporting the assembly with the hoist and sling. Remove shims (3).
Re-extend strut or tilt cylinder (1) until the ball on the strut or tilt cylinder bottoms in the blade socket (4). Reinstall cap (5) with four cap screws (2). Torque cap screws (2) to 270 Nm evenly to ensure the cap is not cocked on the strut ball. Using the removed shims (Fig. 5.41) determine the maximum amount of shims which will fill the gap between the cap (5) and socket (4). When the correct shim pack for the gap between the strut cap (5) and socket (4) is determined add one shim to provide clearance. Each shim is 0.75 mm. Prior to final assembly clean all shims (3), mating surfaces of strut caps (5) and socket (4) mating surfaces of all foreign material, dirt and paint.
Insert the shims over the strut or tilt cylinder ball and extend until the ball bottoms in the blade socket. Install all cap screws (2) and torque to 850 Nm. Readjust blade strut to desired blade angle. TD-40C DRESSTA