MAINTENANCE SECTION 5 Page 49 5.15. MOUNTED EQUIPMENT Fig. 5.41. Adjusting the Upper Strut and Tilt Cylinder 1. Upper Strut 2. Cap Screws 3. Shims 4. Blade Socket 5. Strut Cap 5.15.1.4. Adjusting Blade Pitch Cylinder If blade pitch cylinder is installed instead of upper strut follow to adjust movement between cap and blade socket follow the procedure given for Upper strut and tilt cylinder adjustment. 5.15.2. TRUNNION, COVER, BLADE CUTTING EDGE AND END BITS MOUNTING BOLTS. Check torque of trunnion mounting bolts, bearing cap screws and cutting edge and end bits bolts after initial 10 hours of operation, and then periodically. Refer to “SPECIAL TORQUES”. Fig. 5.42.
Tightening Blade Cutting Edge and End Bits Bolts 1. Bolt 2. Nut DRESSTA TD-40C