DRESSTA Co. Ltd. TD-40C98/1E — 5.15. MOUNTED EQUIPMENT

SECTION 5 MAINTENANCE Page 50 5.15. MOUNTED EQUIPMENT WARNING! Never work beneath the blade without securing it by wooden blocks 5.15.3. ALLOWABLE WEAR OF CUTTING EDGE AND END BITS AND RIPPER POINTS Reverse or replace the cutting edge and end bits before the mounting plate is worn or damaged. To replace the cutting edge and end bits: 1. Raise the blade about 300 mm above the ground and set the pilot valve lever in “HOLD” position. Prop up the push arms and stop the engine. WARNING! Never work beneath the blade without securing it by wooden blocks 2. Remove the cutting edge and end bits mounting bolts. 3.

Install the cutting edge or the end bits and tighten the bolts to the torque specified in “SPECIAL TORUES” in Section 6. 4. Authorized Distributor of Construction Equipment can supply these specially heat-treated bolts. NOTE: Do not substitute bolts. Loosening of bolts mounting cutting edge and end bits may result in tear off cutting edge or end bits and blade damage as well as injury. 5.15.3.1. Servicing the Ripper Prior to each day’s work carry out ripper inspection and remedy if any malfunction is found. Operating defective ripper results in reduced job efficiency and may cause its damage. The following table specifies services to be carried out during inspection:

Replace ripper shank point as follows: 1. Raise ripper tooth about 300 mm above ground and prop up to prevent ripper tooth from lowering during service. 2. Stop the engine. 3. Remove point mounting pin. 4. Install new point and mounting pin. TD-40C DRESSTA POINT OF SERVICE SERVICE DESCRIPTION Ripper Assy Visually check for cracks, breakage, loose parts and completeness Hydraulic hoses and connections Check for leaks and remedy, if any. Hydraulic reservoir Check hydraulic reservoir oil level. Refer to Hydraulic System Ripper pins Check if pins are secured correctly and tighten loosened bolts if necessary. Ripper shank point Check for wear. Replace, if 1/3 of point is worn.

Excessively worn shank point makes ripping difficult.