MAINTENANCE SECTION 5 Page 51 5.15. MOUNTED EQUIPMENT 5.15.3.2. Lubrication Apply lubricant to ripper lube fittings. Service interval of 50 hours refers to average operating conditions. Under unusually severe operating conditions reduce the interval of time between services. Always use clean lubricators and containers. Apply sufficient lubricant to force out old lubricant and dirt. 5.16. SAFETY BELT WARNING! Seat belt – do not clean with solvents or bleach or redye color of webbing as this may cause a severe loss of strength. This could cause the webbing to break and result in personal injury. Wash in warm water with a mild detergent.
Keep belt flat to avoid twisting and roping when not being used. Do not place heavy or sharp objects on belt. The entire seat belt assembly should be inspected periodically for corrosion, wear, fraying or wear spots. The seat belt mounting bolts should also be periodically inspected for tightness. 5.17. FINAL DRIVES 5.17.1. CHECKING THE OIL LEVEL Position the machine on level ground so the “OIL LEVEL” mark on the final drive housing is positioned horizontally. Remove the magnetic filler and level plug, check the lubricant and, if the lubricant is low, fill to the level of the plug opening. Also, check the plug for metallic particles that may be present.
If this condition continues after periodic checks, consult Authorized Distributor of Construction Equipment. Reinstall the plug and tighten. Fig. 5.43. Checking the Lubricant Level 1. Filler and Level Plug 2. Drain Plug DRESSTA TD-40C