DRESSTA Co. Ltd. TD-40C98/1E — 5.18. TRANSMISSION SYSTEM

SECTION 5 MAINTENANCE Page 52 5.17. FINAL DRIVES 5.17.2. CHANGING THE OIL 1. While the oil is at operating or warm ambient temperature, park the machine on level ground so the “OIL LEVEL” mark on the final drive housing is positioned horizontally. Remove the drain plugs (2) and levels plugs (1) and allow the lubricant to drain into a suitable container. Remove metal particles from the magnetic plugs. Install and tighten the drain plugs. Fill app.8 liters of fuel oil up to the housing and install the plugs. 2. Operate the machine in low gear (with no load) for a few minutes. Remove the drain plugs and thoroughly drain the fuel oil into a suitable container.

Reinstall and tighten the drain plugs. Remove the filler and level plugs. Fill the housing with fresh oil up to the bottom of the filler and level plug opening. Refer to the REFILL SPECIFICATIONS AND CAPACITIES chart for grade of lubricant specified. Reinstall and tighten the filler and level plugs. 5.18. TRANSMISSION SYSTEM General The rear frame is the common oil reservoir for the transmission, torque converter and hydraulic steering drive. The system has a pressure filters and a suction strainer which require service. 5.18.1. CHECKING THE OIL LEVEL 1. With the engine shutdown open L.H. side access door, unscrew the T handle of the oil level gauge, remove the gauge and wipe it clean. Fig.

5.44. Rear Frame Oil Level 1. Rear Frame Drain and Fill Receiver (if equipped) and Breather 2. Oil Level Gauge 2. Insert the gauge fully into the filler sleeve. Do not tighten. Remove the gauge and check the lubricant level. If necessary, add oil through the filler to bring the level. Reinstall and secure the gauge. The gauge has two marks: LO for low oil level and HI for high oil level for HOT oil on one side and two marks: LO for low oil level and HI for high oil level for COLD oil on the other. Check oil level with engine stopped. NOTE: Never operate the machine if the level of the oil is at or below the LOW mark on the oil level gauge. TD-40C DRESSTA