OPERATING SECTION 4 Page 31 OPERATING MOUNTED EQUIPMENT Fig. 4.28. Hydraulic Pin Puller Control Lever I - Shank Pin Removal II - Shank Pin Installation III - Hold 4.19. OPERATING TECHNIQUES WARNING! Before operating the machine, be sure the area of the operator's compartment, all mounting steps and grab handles are free of oil, grease, loose objects, ice, snow and mud to lessen the possibility of slipping. Remove or secure all maintenance and personal items so they will not interfere with the operator or jam the controls. Failure to follow these instructions may result in serious injury.
When the blade is held hydraulically it becomes a rigid part of the tractor, except when the valve is in “FLOAT” position, and will follow all movements of the tractor. When rough terrain encountered it will be necessary to vary the height of the blade while pitching to obtain a smooth cut. When possible, start all jobs from relatively level ground. If necessary, level an area large enough to provide sufficient working space for the tractor. This prevents back and forth pitch of the tractor and will result in easier digging. Avoid track spinning whenever possible; this wastes effort and converts a relatively smooth working area into ruts and piles that pitch and tilt a tractor.
In cold weather this material can freeze and cause additional difficulty the following day. Crossing ditches, ridges, rock or logs should be done slowly and, at an angle. This slows the fall, lessens the danger of upsetting the machine and reduces the fall jolt, which can be harmful to the operator and machine. 4.19.1. DIGGING AND CLEARING WARNING! Prior to operating know the locations of gas lines, utility lines, sewers, overhead and buried power lines, and the other obstructions or hazards are known. A raptured gas line or cut electrical line could result in personal injury. DRESSTA TD-40C